[olug] It works

[Jon]

all that sound config does is load the module.  I would suggest doing a modprobe on the module name yourself.  If you get it working just add the modprobe to your statup routine.  Do you know wich kernel module it needs?

-Jon

On Mon, Sep 03, 2001 at 10:17:04PM -0500, Tom Huber wrote:
> Jon wrote:
> 
> > What sound chipset is it running?
> >
> > > Now if I could get the darn sound card working again, it was before the eth0
> > > problem but pulled it out to eliminate ANY possible conflicts.  It does show
> > > up now as the only PNP device on a probe and it does detect the correct card
> > > but when I run sndconfig to configure it is just sits there and never
> > > finishes.  Ain't this fun.
> > >
> > > Tom
> 
> It is the Ess1868.  When I run sndconfig it says it found it then goes to sleep
> and never ask to test it or set it up.  isapnp says it found it  too.  It works
> fine in W98 and before my eth0 problem (when I pulled it out) worked fine here
> too.
> 
> Tom
> 
> 
> -_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_
> 
> For help contact olug-help at bstc.net - run by ezmlm
> to unsubscribe, send mail to olug-unsubscribe at bstc.net
> or `mail olug-unsubscribe at bstc.net < /dev/null`
> (c)2001 OLUG http://www.olug.org
> 
> -_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_

-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_

For help contact olug-help at bstc.net - run by ezmlm
to unsubscribe, send mail to olug-unsubscribe at bstc.net
or `mail olug-unsubscribe at bstc.net < /dev/null`
(c)2001 OLUG http://www.olug.org

-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_