[olug] Cisco Aironet 340 Wireless card

[neal rauhauser]

 Explore the parameters that are used when you load the module - if I
recall correctly there are some things that can only be done at load
time. Funny, I know, it surprised me when I found it.


 
> --- neal rauhauser <neal at lists.rauhauser.net> wrote:
> >
> >
> >  What is neat? I'm not on redhat and haven't been
> > for a long time.
> >
> 
> Neat is a Network Setup/Configuration Tool.
> 
> After I put up this post I tried different variations
> of the "iwconfig" command with very little change.
> 
> I did "/sbin/iwconfig eth0 channel 6" to set it to the
> correct channel on my AP/router.  I also tried a bunch
> of different modes, "/sbin/iwconfig eth0 mode Auto"
> also tried Managed, Ad-hoc, and Monitor.  Seems only
> Managed can be set, I get errors when I try Auto,
> Ad-hoc and Monitor modes.
> 
> I still cant seem to get the interface up and running,
> I have the status light on and the activity led is
> blinking repeatedly, but I just can get the device
> active and I cant ping my router/gatway or any other
> nodes on my network. "/sbin/ifconfig still shows RX
> and TX errors".  Im really confussed as to what to do
> next.
> 
> 
> __________________________________
> Do you Yahoo!?
> Yahoo! Mail - 50x more storage than other providers!
> http://promotions.yahoo.com/new_mail
> _______________________________________________
> OLUG mailing list
> OLUG at olug.org
> http://lists.olug.org/mailman/listinfo/olug

-- 
==================================================================
mailto:neal at lists.rauhauser.net http://www.rauhauser.net fcc:K0BSD
Cisco, Soekris, OpenBSD, or Amateur Radio? See my web page ...
==================================================================