[olug] Qpest PPPoA authentication?

[Dave Weis]

On Tue, 22 Nov 2005, Neal Rauhauser wrote:
> I have customer who has agreed to replace their Qwest ActionTech DSL modem 
> with a Cisco 1720+WIC-1ADSL.
> The config below causes ATM0 to go up/up, I know the userid and password I 
> have are correct, but in watching console messages it says I need some sort 
> of authorization setting. Has anyone dealt with this before on Qwest's 
> network? I played a bit with aaa authorization commands but I was just 
> throwing darts - it'd be really nice if someone could cough up the one liner 
> I'm missing here ...

This is what I've got on a 2600 with the same wic. I don't think you want 
CHAP. You probably shouldn't specify the IP either, it will get passed by 
the NAS/Radius server on the far end. Everything else looked fine.

interface Dialer0
  ip address negotiated
  no ip proxy-arp
  encapsulation ppp
  dialer pool 1
  dialer vpdn
  dialer-group 1
  ppp pap sent-username username password 7 encryptedpw

> interface Dialer0
> ip address [removed]
> encapsulation ppp
> dialer pool 1
> dialer-group 1
> no cdp enable
> ppp authentication ms-chap
> ppp chap hostname removed
> ppp chap password 0 removed
> !
> ip route 0.0.0.0 0.0.0.0 Dialer0
> dialer-list 1 protocol ip permit

-- 
Dave Weis
djweis at internetsolver.com
http://www.internetsolver.com/