[olug] network problem

[Jon]

Try a different cable.  I have run into so many bad cabes you never can be sure.

-Jon W


On Fri, Jun 15, 2001 at 08:32:39PM -0500, J Randall Wilson wrote:
> It's official.  I'm baffled.
> 
> The lights are on, blink on ping and no answer.
> 
> I have two computers connected with a cross-over cat5.  Continuity checked.
> 
> 
> Commands:
> root:~$ ping 192.168.1.4
> PING 192.168.1.4 (192.168.1.4): 56 octets data
> 
> --- 192.168.1.4 ping statistics ---
> 12 packets transmitted, 0 packets received, 100% packet loss
> 
> root:~$ telnet 192.168.1.4
> Trying 192.168.1.4...
> telnet: Unable to connect to remote host: No route to host
> 
> 
> Configuration:
> root:~$ ifconfig
> eth1      Link encap:Ethernet  HWaddr 00:C0:26:A0:AF:74
>           inet addr:192.168.1.3  Bcast:192.168.1.255  Mask:255.255.255.0
>           UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
>           RX packets:0 errors:0 dropped:5 overruns:0 frame:0
>           TX packets:0 errors:9 dropped:0 overruns:0 carrier:0
>           collisions:0 txqueuelen:100
>           Interrupt:12 Base address:0x300 Memory:ffffffff-ffffffff
> 
> lo        Link encap:Local Loopback
>           inet addr:127.0.0.1  Mask:255.0.0.0
>           UP LOOPBACK RUNNING  MTU:3904  Metric:1
>           RX packets:32 errors:0 dropped:0 overruns:0 frame:0
>           TX packets:32 errors:0 dropped:0 overruns:0 carrier:0
>           collisions:0 txqueuelen:0
> 
> root:~$ route -n
> Kernel IP routing table
> Destination     Gateway         Genmask         Flags Metric Ref    Use Iface
> 127.0.0.1       0.0.0.0         255.255.255.255 UH    0      0        0 lo
> 192.168.1.0     0.0.0.0         255.255.255.0   U     0      0        0 eth1
> 
> 
> Solution very much appreciated!
> 
> Randy
> 
> 
> ---------------------------------------------------------------------
> To unsubscribe, e-mail: olug-unsubscribe at bstc.net
> For additional commands, e-mail: olug-help at bstc.net

---------------------------------------------------------------------
To unsubscribe, e-mail: olug-unsubscribe at bstc.net
For additional commands, e-mail: olug-help at bstc.net