[olug] network problem

[bbrush at unlnotes.unl.edu]

Sounds like the cable to me too.  You can get a connection light without
actually having a connection.

Bill
***************************Reply separator********************


                                                                                                      
                    J Randall                                                                         
                    Wilson               To:     <olug at bstc.net>                                      
                    <jrwilson at qwe        cc:                                                          
                    st.net>              Subject:     [olug] network problem                          
                                                                                                      
                    06/15/01                                                                          
                    08:32 PM                                                                          
                    Please                                                                            
                    respond to                                                                        
                    olug                                                                              
                                                                                                      
                                                                                                      




It's official.  I'm baffled.

The lights are on, blink on ping and no answer.

I have two computers connected with a cross-over cat5.  Continuity checked.


Commands:
root:~$ ping 192.168.1.4
PING 192.168.1.4 (192.168.1.4): 56 octets data

--- 192.168.1.4 ping statistics ---
12 packets transmitted, 0 packets received, 100% packet loss

root:~$ telnet 192.168.1.4
Trying 192.168.1.4...
telnet: Unable to connect to remote host: No route to host


Configuration:
root:~$ ifconfig
eth1      Link encap:Ethernet  HWaddr 00:C0:26:A0:AF:74
          inet addr:192.168.1.3  Bcast:192.168.1.255  Mask:255.255.255.0
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:0 errors:0 dropped:5 overruns:0 frame:0
          TX packets:0 errors:9 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:100
          Interrupt:12 Base address:0x300 Memory:ffffffff-ffffffff

lo        Link encap:Local Loopback
          inet addr:127.0.0.1  Mask:255.0.0.0
          UP LOOPBACK RUNNING  MTU:3904  Metric:1
          RX packets:32 errors:0 dropped:0 overruns:0 frame:0
          TX packets:32 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:0

root:~$ route -n
Kernel IP routing table
Destination     Gateway         Genmask         Flags Metric Ref    Use
Iface
127.0.0.1       0.0.0.0         255.255.255.255 UH    0      0        0 lo
192.168.1.0     0.0.0.0         255.255.255.0   U     0      0        0
eth1


Solution very much appreciated!

Randy


---------------------------------------------------------------------
To unsubscribe, e-mail: olug-unsubscribe at bstc.net
For additional commands, e-mail: olug-help at bstc.net





---------------------------------------------------------------------
To unsubscribe, e-mail: olug-unsubscribe at bstc.net
For additional commands, e-mail: olug-help at bstc.net